3/2/2024 0 Comments Tanning hides with alumScrape off the paste and rinse the pelt repeatedly under running water until there is no trace of Borax. Repeat this procedure three more times, leaving the last coating in place for three to four days. Leave the paste on the skin until the next day, then scrape it off and apply another coating. Put on rubber gloves and work the paste with your fingers, rubbing it firmly into the skin. Mix the paste well to remove any lumps.Coat the inside of the pelt with the Borax paste, using a knife to spread it to a thickness of 1/8 inch. Now you rinse the pelt in warm water and squese the water out DO NOT WRING THE PELT Use a stick or somthing made from wood to stir the skin around in the solution. Doing this cleans the skin so it will accept the tanning better. For greasy skins, adding a tablespoon of dishwashing soap per gallon of water may help clean the skin. When the skin is almost soft, put it in lukewarm water containing an ounce of baking soda or Borax per gallon. Take care not to injure the true skin or expose the hair roots, especially on thin skins like squirrel and rabbit. ![]() All dried skins have a shiny tight layer of tissue that must be broken up and entirely removed this can be done by alternately scraping and soaking the hide. When the skin begins to soften, lay it on a smooth board and begin working over the flesh side to break up the adhering tissue and fat. Soaking time depends upon the condition of the skin some skins require only about two hours while others need a much longer time. ![]() While a skin must be soaked until soft, do not allow it to stay wet longer than necessary because the hair may start to slip. Never use a metal container, as the salt and tanning chemicals can react with the metal. Use a 5 gallon plastic garbage can for all soaking and tanning processes. Soak the skin in several changes of cool water.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |